TEST & VERIFY

Know what your
board actually does.

We bring your prototype onto the bench and check it against its intended behaviour—from power-up and supply rails to interfaces and core functions.

Two probes contacting test pads on a 3D PCB
02 / Test & VerifyIllustrative engineering study

SCOPE CAN INCLUDE

What we do

  • Test planning against intended behaviour
  • Board inspection and initial bring-up
  • Power and supply measurements
  • Agreed interface and functional checks
  • Recorded results and open issues

AGREED FOR YOUR PROJECT

What you receive

  • An agreed test plan
  • Measurements and observations tied to the board revision
  • A report of passes, failures and limitations
  • Recommended next steps

01 / THE PROCESSAgree the checks.

Define what the board should do, the operating conditions and the measurements that will demonstrate it. The test scope is agreed before bench work begins.

02 / THE PROCESSMeasure systematically.

Inspect the board, bring it up carefully and work through the agreed checks. Record the conditions alongside the readings so the results remain useful.

03 / THE PROCESSMake the results usable.

Explain what passed, what failed and what remains untested. Where a fault needs investigation, agree the next diagnostic step.

A SCOPE THAT FITSProject-based support.

Get specialist help for this stage without committing to a full-time hire. We agree the deliverables, price and schedule around your requirements.

How engagements work

TO GET STARTEDWhat to share.

  • Schematic, board revision and available design files
  • Board samples and power requirements
  • Firmware and instructions needed to operate the board
  • Expected behaviour and known issues
Prepare a project brief

RELATED WORK / IN PROGRESSFrom prototype problem
to a custom board.

A wireless sensing project brings design review, a new board and a planned test programme into one engagement. Prototype boards are ordered; bench results are pending.

Explore the project

Tell us about your project.

Discuss board testing